Which command will help you configure this requirement?

Correct Answer for the Question – Which command will help you configure this requirement? is given below

On your Oracle Linux 6 system, you have to configure the eth0 network interface to 100 MB/sec, half duplex without trying to autonegotiate. Which command will help you configure this requirement?When I have a device that is acting up, I tend to run: ethtool ethX, check the Supported link modes, the Link partner advertised link modes and the actual speed and Duplex. If my Supported link mode is set low (say 10/Half for some reason) but my switch supports 1000baseT/Full then I’ll use ethtool -s ethX to change my ethernet settings to 1000baseT/Full. Just about anything you see from: ethtool ethX, can be changed with ethtool -S ethX. In this case you would use the following:ethtool -S eth0 speed 1000 duplex full autoneg on

# ifconfig eth0 speed 100 autoneg off duplex half

# ethtool interface eth0 speed 100 autoneg off duplex half

# ifconfig interface eth0 speed 100 autoneg off duplex half

# ethtool -s eth0 speed 100 autoneg off duplex half

Correct Answer

The Correct Answer for this Question is

# ethtool -s eth0 speed 100 autoneg off duplex half

Explanation

The Question – Which command will help you configure this requirement? has been answered correctly and answers for the question is # ethtool -s eth0 speed 100 autoneg off duplex half

More about these Exams

These Exam Questions and the order of these questions keep changing. but the answers are obviously same. so if you don’t find a question after another we suggest you search it in the search box and we are sure you’ll find it. you can bookmark this site for Quick access in future.

We hope you found it helpful don’t forget to leave a comment if you feel a need to correct or ask we’re always here to help.

you can find more here at Certout

Feel free to contact via comment or email.

Happy Learning

Cheers, Team Certout

Leave a Comment